Ignite ux copy system files

I hope you have regular backups of the files you're not putting onto the recovery archive from vg Please go through the MAN pages for option detail.

Honored Contributor. The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation. End of content United States. Hewlett Packard Enterprise International.

Now, boot the client from the Ignite-UX server using any method you wish. When you install the client, you can select from the recovery configurations of the source client. Note: The src-client may have non-vg00 VGs that must be handled. If the target-client is not going to use the old VGs, use vgexport to clean up the directories and lvmtab.

Tags: HP-UX , systems. Cloning a system with Ignite. Many applications use file locking and can hang in this situation.

Most common are user home directories that are NFS mounted, in which case sh and ksh will attempt to lock the. When a system is running and has an active NFS mount with a server in which files have been previously locked, both the client and server cache information about each other. Part of the information that is cached is what RPC port number to use to contact the rpc. This RPC port information is cached in memory of the running rpc. The rpc.

During a normal reboot or crash, rpc. In this case, if the reinstalled system tries to recontact a server that has cached information, the server will try to communicate over an old RPC port. The communication will fail for rpc.

If you are using bootsys to install clients, use the -s option to allow the client to shutdown normally and inform servers that it is going down. If more than one server is involved, you may end up doing this multiple times until all servers are notified. This will cause the first boot to generate a crash recovery notification message to each server, causing it to purge the stale port information.

With bootsys -w client , the client does not wait for the server. With bootsys client , the client waits for the server.

This was probably due to running through the GUI once on the server prior to running bootsys. The server drops the instruction for the client to start installing, and the next time the client boot s it picks that instruction up and goes. Ignite-UX tells you that the installation will happen the next time bootsys -w is used, but does not say it happens automatically.

Then, the next time you run bootsys , you did not use the GUI without the client being booted from the server. The search lan install command does not list the server. Check these items on the Ignite-UX server from which you are trying to boot :. A message in syslog. Also, for these older clients, there is an intentional delay built into the rbootd process when a client wants to do an installation boot as opposed to a diskless boot. This prevents the server from showing up during the first search.

Retrying the search two or three times may be necessary. To correct this situation, you may need to remove any backup kernel s.